The screw anchor is an innovative anchor system for fastening wall saws to concrete and other solid masonry. When screwed in, the screw anchor cuts a thread into the drill hole with its saw-tooth-shaped thread turns and creates a positive, expansion-free connection. With the nut (M12) the rail bracket can be set up easily for cutting.
Area of application: for fastening rail brackets of all manufacturers; normal concrete of strength class at least C20/25 and at most C50/60, as well as solid sand-lime brick, perforated sand-lime brick, clay brick and lightweight concrete.
Note: Thanks to the test sleeve, the screw anchors can be reused several times for fastening rail brackets.
Advantages:
- Approved for masonry
- Shallow drill hole depths and small drill hole diameters
- Saw teeth in the front area of the anchor ensure minimal screw-in torque
- No expansion effect, therefore small axial and edge distances
- Simple and fast push-through installation; machine setting with an impact wrench is no problem
- Immediately loadable – no waiting times
- Fastening can be completely dismantled again
- No torque control necessary
Anchor diameter x anchor length
12 x 110 mm
Nominal drill diameter
10 mm
Connection thread
M12 x 30
Drill hole depth
100 mm
Frequently asked questions
What is Concrete Anchor with Cutting Thread for Wall Saws used for?
The screw anchor is an innovative anchor system for fastening wall saws to concrete and other solid masonry.
Where can I get advice on Concrete Anchor with Cutting Thread for Wall Saws?
At DTI-M GmbH, Handwerkstraße 26, 91186 Büchenbach, Germany, phone +49 09171 8522033. You can also order directly online in the shop.
